







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
James Hardie Driveway & Pavers: The Sunrise Manor Owner’s Guide
If your James Hardie driveway or paver system is heaving, chipping, or pulling apart at the seams, a full replacement usually runs $7,000 – $18,000 for paver work and $4,500 – $12,000 for a concrete pour in Sunrise Manor. We install and correct James Hardie-compatible hardscape systems across Sunrise Manor, and we quote most jobs within a few days of the site visit. That said, we’re an independent contractor, not James Hardie itself, so we match the material spec to your existing layout rather than selling you a boxed part off a shelf.

Owners usually spot the problem in stages. First comes the hairline crack near the garage apron. Then a paver edge lifts half an inch after a summer. By the third monsoon season, water pools against the foundation and the joints never really close again. Sunrise Manor’s caliche-heavy soil and 100-degree swings don’t forgive a thin base, and that’s where most failures start.
Which James Hardie Models This Applies To

James Hardie’s exterior and hardscape lines carry different model and series designations depending on the product family, and the right match depends on what’s actually installed at your address. Pull a tape measure and check the substrate thickness, the paver face dimensions, and the edge restraint profile. The label on the original packaging is almost always long gone, so photos and measurements are your best identification tools.
For a Sunrise Manor homeowner with a failing system, the honest answer is: we rarely need to match a specific model number. Driveway and paver work is a system, not a swappable cartridge. What matters is base depth, drainage slope, and joint sand spec. We can match James Hardie-compatible components to your existing layout, or step up to a comparable Belgard or Unilock spec if the original line has been discontinued.
OEM vs aftermarket comes down to a simple question. If the rest of the system is healthy and you’re replacing one section, we match as closely as possible to the original. If the whole drive is failing, the “matching part” conversation is over, and we spec a full system that meets or exceeds the original engineering. We also work with KraftMaid, Cambria, and Silestone on interior projects for owners who want one contractor across the home.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your James Hardie Driveway & Pavers Is Failing
- Lifted or rocking pavers. The base has lost compaction, usually from that first heavy rain pushing water under the edge. Once one paver rocks, the joint sand channels loose and the failure spreads.
- Hairline cracks along the apron. Concrete cracking at the garage transition is a base issue, not a surface issue. That gap lets water wick under the slab and freeze-lift in the cooler Sunrise Manor nights.
- Chipping or spalling on the paver faces. UV exposure and salt from winter irrigation speed this up. Once the face is compromised, the surface will keep flaking no matter how many times you reseal it.
- Ponding water after storms. A sunken section or a flattened slope means water is sitting on the system instead of draining away. Left alone, that water finds the foundation and the soil under the house.
- Joint sand washing out faster than it should. Fast sand loss means the joint profile is no longer holding. Either the sand spec is wrong or the subsurface water is pushing through the joint on every rain.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
These are the ranges we quote most often in Sunrise Manor, and every number is delivered as a written line-item price before the first tool comes out:

- Paver driveway installation: $7,000 – $18,000
- Concrete driveway installation: $4,500 – $12,000
- Driveway replacement (full removal and rebuild): $5,000 – $14,000
- Asphalt driveway paving: $3,500 – $9,000
- Driveway sealing (protective coat): $250 – $700
- Paver patio installation: $3,500 – $11,000
What drives the range: linear square footage, substrate condition, removal and haul-away, edge restraint, and drainage corrections. Pavers at the higher end of that range usually reflect a larger footprint or added drainage work. Every completed job is backed by the 365-Day Done Right Promise, our written guarantee that runs a full year from project completion. If the work fails inside that window, we come back and correct it at no charge.
DIY or Call Us?
You can safely check a few things on your own. Walk the driveway after a rain and note where water pools. Photograph cracks and lifted pavers with a tape measure in frame. Check whether the joint sand has washed out along the edge restraint. That’s the right level of inspection for an owner.
What goes wrong in DIY driveway and paver work is almost always in the base, not the surface. We’ve seen plenty of owner-installed drives look fine for one season and fail by the second because the base wasn’t compacted to depth, or the slope ran back toward the house. Ripping out a driveway also means dealing with caliche, haul-away, and edge restraint fastening – jobs that go wrong quietly and expensively. If you’re looking at patching a section, we can talk honestly about whether that’s worth it. If you’re looking at a full replacement, call us at (844) 834-2810 to schedule a free estimate.
FAQs

A properly installed concrete driveway holds 25 to 30 years in this climate, and paver systems run 20 to 25 years before hardscape repair becomes the better option than replacement. The number that actually matters is base depth: a thin base or inadequate slope clips a decade or more off both estimates. Call (844) 834-2810 for an exact quote – estimates are free.
Often, yes. Localized paver lifting, joint sand loss, and edge restraint failures can be corrected without a full tear-out if the base under the affected area is still sound. We test the base before recommending repair versus replacement. If repair is the right call, we tell you; if it’s throwing money at a system that’s failing underneath, we tell you that too.
A typical paver driveway runs three to five working days from demo through final compaction, and a concrete pour runs two to four days plus cure time. Larger footprints, drainage corrections, or caliche removal add days. You get the schedule in writing before work begins.
We source through documented distribution channels tied to the original spec, then match components – base aggregate, edge restraint, joint sand – to your existing system or to a compatible Belgard or Unilock line if the original has been discontinued. We don’t stock parts and we don’t pretend to. Every material spec is in the written quote so you can see exactly what’s going onto your driveway in Sunrise Manor.
Written by the team at Bradford Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












