







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Bathroom Remodeling: The Sunrise Manor Owner’s Guide
If you’ve traced a failed shower pan liner, a leaking pan, or a cracked fiberglass base back to a Tamko-system bathroom build, replacement in Sunrise Manor typically runs $9,000 – $28,000 for a full bathroom remodel, and a targeted pan or surround replacement sits at the lower end of that range. We install Tamko-compatible bath systems, and because we give a written price before any work starts, you’ll know the number before a shower pan comes out.

Owners usually find the problem the same way: a soft spot in the shower floor, a bulge in the fiberglass base, or water showing up on the ceiling of the room below after a shower. It rarely announces itself. It just gets worse under a tile job that looked fine for years.
Key Takeaways:
- Full Tamko-system bathroom remodels in Sunrise Manor run $9,000 – $28,000.
- We’re an independent contractor, not affiliated with Tamko; we build to its spec.
- Every job gets a written price before work begins and the 365-Day Done Right Promise.
Which Tamko Models This Applies To

Tamko’s bath line is built around a handful of shower-pan and wall-surround systems, and getting the part right starts with identifying what you actually have under the tile or surround. The label on a Tamko pan is usually on the underside or the drain flange, and if it’s been tiled over, we measure the pan footprint, the drain center, and the wall heights instead. Those three measurements tell us which pan and surround series it matches.
Here’s the compatibility gotcha that trips up Sunrise Manor owners buying parts online: Tamko pans are sold in specific drain-center offsets and left/right drain configurations, and the drain position has to match the rough-in in your floor. A pan that’s an inch off on drain center doesn’t fit, period. That single measurement is why a parts-shelf guess usually becomes a return.
On the OEM-versus-aftermarket question, the honest answer is that a quality aftermarket pan made to the same drain spec will work fine, but the surround trim and the waterproofing membrane should match the system you’re assembling. We source parts to your exact Tamko series and rough-in, then note the spec on your written quote so nothing is left to guesswork.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Bathroom Remodeling Is Failing
- A soft or spongy shower floor. That’s the pan or the substrate under it losing integrity, often from water that’s been sitting under the tile for a while.
- Water stains on the ceiling below. Your shower pan or the drain seal is leaking, and it’s finding the path of least resistance down through the floor assembly.
- Lifted or hollow-sounding tile near the drain. The waterproofing layer has failed at the drain connection, so tile bonding is breaking down from underneath.
- Cracks in the fiberglass base or a flexing wall panel. Sun and heat here are hard on fiberglass, and a base that flexes underfoot is already compromised.
- Persistent musty smell that returns after cleaning. That’s trapped moisture in the wall cavity or substrate, which points to a surround or membrane failure you can’t see.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

In Sunrise Manor, a full bathroom remodel using Tamko-compatible systems runs $9,000 – $28,000. A smaller bathroom remodel with a targeted pan and surround replacement sits at $5,000 – $12,000. A walk-in shower installation runs $4,500 – $12,000, and a tub-to-shower conversion runs $3,500 – $10,000.
What drives the range: whether the pan is tiled or pre-formed, how much plumbing has to move to match the drain rough-in, and whether the surround goes floor to ceiling. Labor for removing the old pan and prepping the substrate is a real line item, not a rounding detail. Your written quote lists parts and labor separately, and the whole job is covered by the 365-Day Done Right Promise: if the work fails within a year, we come back and correct it at no charge.
DIY or Call Us?
Pulling a failed shower pan is not a weekend job, and this is one part where we say so plainly. A pan replacement means cutting out the old base, re-doing the waterproofing, and re-setting the drain so it passes a leak test. Get the waterproofing wrong and you’re back to a stained ceiling downstairs in a year or two. It’s not a matter of skill so much as the order of operations and getting the drain seal absolutely right.
What you can safely do is check for soft spots, look at the pan label, and measure the drain center and footprint. That’s information we need anyway. If you’ve got water showing below the shower, stop using it and call us at (844) 834-2810. Estimates are free and the price is written before work starts.
FAQs

How long does a Tamko shower pan last? A properly installed Tamko pan typically serves 15 to 25 years, but Sunrise Manor’s hard water and summer heat shorten that. Mineral buildup and heat cycling at the drain are the usual cause of early failure, so a pan in this climate often fails closer to the 15-year mark. Call (844) 834-2810 for an exact quote on replacement.
Can a failed Tamko pan be repaired instead of replaced? Sometimes, if the failure is a single cracked section and the substrate underneath is dry and sound. A leak that’s already reached the room below almost always means replacement, because the damage runs wider than the visible crack. We’ll tell you which one you’re facing during the free estimate.
How long does the swap take? A targeted pan and surround replacement usually runs two to four days, plus a day for the leak test and drying. A full bathroom remodel runs longer, typically two to three weeks, depending on scope. Your written quote gives you the timeline before we start.
How do you source the Tamko part? We measure your pan footprint, drain center, and drain configuration, then order to that spec from a supplier, whether OEM or a quality aftermarket equivalent. The part and its spec go on your written quote. We don’t carry parts on a truck, so the order is matched to your job before install. Call (844) 834-2810 to get that measurement started.
We also install KraftMaid, Cambria, and Silestone in the same bathroom when the scope grows. Bradford Remodeling Sunrise Manor gives you a written price before any work begins and stands behind every completed project with the 365-Day Done Right Promise, backed by background-checked, uniformed technicians who show up when scheduled. Call (844) 834-2810 for a free estimate.
Written by the team at Bradford Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












