







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Schluter Driveway & Pavers: The Sunrise Manor Owner’s Guide
We install and repair Schluter-compatible driveway and paver systems in Sunrise Manor, and a full paver driveway installation here typically runs $7,000 to $18,000 depending on square footage, base prep, and the drainage profile of your lot. Paver patio work lands between $3,500 and $11,000. If a Schluter profile, edge restraint, or drainage mat has failed under your driveway or patio, we can usually assess it and quote a fix within a day of your call.

Most Sunrise Manor owners find out something went wrong the same way: a paver edge starts riding up along the driveway apron, or the transition strip between the garage slab and the pavers pops loose after a summer. You notice a wobble underfoot near the border, or a hairline gap opens along the Schluter profile where water has been getting in. Then the next monsoon pushes sand and water into the joint and the problem announces itself. Once that edge lifts, the whole border course is working loose.
One note on who we are: Bradford Remodeling Sunrise Manor is an independent contractor, not affiliated with Schluter. We work with Schluter-system components daily, which means we know the parts and the failure patterns, and we quote honestly on what your specific system needs.
Which Schluter Models This Applies To

Schluter’s paver and hardscape line covers a few distinct families, and Sunrise Manor homeowners usually need one of two things. Exterior drainage and edge profiles (the systems that manage water at a paver-to-slab or paver-to-wall transition) are the usual failure point on desert driveways. Paver joint and surface substrates are the other. Schluter’s exterior profile lines come in several build heights and flange depths, and the profile height has to match your paver thickness within a couple of millimeters, or the flange sits proud of the surface and takes traffic load directly.
To identify the right part, pull a sample paver if you can. Measure the thickness at the center and at the edge (they’re not always the same on tumbled pavers). Check the profile’s flange depth against the substrate depth you’re transitioning to. The label on the original packaging, if you kept it, will have the series name and dimensions.
On OEM versus aftermarket: for Schluter exterior profiles, match the manufacturer’s series spec. Generic edge restraints are cheaper but usually don’t meet the same load rating, and in Sunrise Manor’s heat, the wrong plastic formulation goes brittle in a single summer. Our technicians have up to 22 years of experience with these systems, and we’ll tell you when an aftermarket equivalent genuinely works and when it doesn’t.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Schluter Driveway & Pavers Is Failing
- Edge profile lifting along the driveway apron. The flange has lost engagement with the base course, usually because the sand bed migrated after a monsoon. Once it lifts, water runs under the profile and erodes the base each time it rains.
- Gaps or separation at the paver-to-wall junction. Thermal cycling in Sunrise Manor swings wide: 100°F+ summer days down to cool desert nights. Profiles with a rigid flange can crack at the corner where the pavement meets the home.
- Pooling water near the transition strip. This usually means the profile’s drainage channel is clogged or the slope correction under the paver border has failed. Standing water at the edge accelerates everything else.
- Loose border pavers wobbling around the profile. The joint sand has washed out and the profile is no longer capturing the border course. Left alone, that edge course will displace one paver at a time.
- Visible rust or discoloration on metal profiles. In our climate, cheap or incorrectly specified profiles break down faster than expected. A rusting edge means moisture is staying under the profile, not shedding off it.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Here’s what a Schluter-profile repair or replacement actually costs in Sunrise Manor:
| Scope | Installed Price Range |
|---|---|
| Single edge profile replacement (up to 20 linear feet) | $350 – $900 |
| Full perimeter profile replacement (up to 60 linear feet, typical driveway apron) | $900 – $2,200 |
| Border course reset with new profile and joint sand | $600 – $1,800 |
| Paver section lift-and-reset over failed base at profile | $800 – $2,500 |
| Full paver driveway installation (new) | $7,000 – $18,000 |
The spread comes down to how much paver surface has to come up to get at the profile, and how much base course needs correction. Base prep in the east Sunrise Manor neighborhoods, where some lots sit on fill rather than the fossil-stable caliche further west, can add a day or two of soil correction that doesn’t show up on other quotes.
You get a written price before any tool comes out. Every job carries the 365-Day Done Right Promise: if the repair or installation fails inside that full year, we come back and correct it at no charge. A live person answers our phone 24/7 at (844) 834-2810, and yes, we pull the permits if the scope crosses into structural or drainage work that requires them.
DIY or Call Us?
An owner can safely do a few things. You can sweep out joint sand and refill it. You can check for wobble by walking the border course. You can confirm the profile series by finding an old package or measuring the flange depth. You can flush a drainage channel with a hose to see whether water sheds or pools.
What you can’t safely do yourself: lift and reset a paver border that sits over a bedrock-hard caliche layer or, worse, over uncompacted fill. A paver that comes up without the base being corrected will fail again inside one season, and the profile you replaced won’t be the problem. We see failed homeowner resets along the Sunrise Manor border strip regularly, and the cost of redoing the work is always higher than doing it right the first time. Call (844) 834-2810 and we’ll walk your driveway with you and give you a written quote.
FAQs

Expect 10 to 20 years for a properly specified profile in our climate, and less, closer to 6 to 10 years, if the base underneath was never corrected. The desert sun degrades plastic and cheap metal profiles faster than in cooler regions, and monsoon water accelerates base erosion. When we quote a replacement, we look at whether the base is the real limit before pricing a new profile.
Sometimes, yes. If the profile is intact and only the joint sand has washed out or the border course has shifted, a reset with new joint sand and correct base prep can fix it. We don’t recommend repair if the profile has cracked, bent, or is holding water against the foundation. We’ll give you an honest answer on that when we walk it.
A single edge profile replacement is typically a one-day job. Full perimeter work with a border course reset runs two to three days, mostly because we slow down on base prep around the transition. New paver driveway installation ranges from three to five days on a standard Sunrise Manor lot.
We spec the profile by series name and dimensions against the original Schluter product line, then order through the manufacturer’s distribution for exterior grading. We don’t claim to carry parts on a truck, because we don’t. Every part is specified and ordered to your system. That’s how we guarantee the right fit, and why our written price is fixed before work starts.
Bradford Remodeling Sunrise Manor also installs KraftMaid cabinetry, Cambria and Silestone surfaces, and other documented brand systems as part of our remodeling work. Every project, whether it’s a driveway edge or a kitchen, follows The Garrison Standard with a written price, background-checked uniformed technicians, and the 365-Day Done Right Promise in writing at close.
Call (844) 834-2810 for a free estimate on your Schluter driveway or paver system in Sunrise Manor. A live person picks up, any hour.
Written by the team at Bradford Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












