







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Moen Bathroom Remodeling: The Sunrise Manor Owner’s Guide
Moen bathroom remodeling in Sunrise Manor typically runs $9,000 to $28,000 for a full bathroom, with Moen faucet, trim, and valve work built into the written scope. We install to Moen’s published rough-in specs, and we pair every Moen fixture with the right valve body and cartridge for the model you actually have – not a generic match. Most Sunrise Manor owners land on this page because a single Moen part gave out first: a cartridge that drips at 2 a.m., a shower trim that no longer seals, or a Posi-Temp handle that runs lukewarm no matter where you turn it.

Key Takeaways
- Moen bathroom remodeling in Sunrise Manor: $9,000 to $28,000 installed, written price before work starts.
- Smaller Moen-focused scopes, like a vanity or shower replacement, run lower – see the cost table below.
- Moen models matter here. A 1222 cartridge and a 1200 cartridge look similar and are not interchangeable. We match before we quote.
- Every completed project carries the 365-Day Done Right Promise in writing. If the work fails inside a year, we come back and correct it at no charge.
Which Moen Models This Applies To

Moen parts are not one-size. The two most common bathroom cartridges in Sunrise Manor homes are the 1222 (brass body, used in Moentrol and many two-handle tub/shower valves) and the 1200/1200B (plastic body, common in single-handle builds). They share a footprint but different stems, and swapping the wrong one is how a five-minute job turns into a valve replacement. Before ordering, we read the model number stamped on the valve’s rough-in plate or under the trim escutcheon. If the tag is gone, we measure the cartridge length and seat diameter and cross-reference against Moen’s published spec sheet.
Two named Moen lines come up most often in Sunrise Manor remodels: Chateau (entry-level) and Brushed Nickel finishes across the Boardwalk and Kingsley series. OEM Moen cartridges carry a lifetime limited warranty, which matters for repeat cartridges. Aftermarket equivalents cost roughly half, run a shorter rated life, and void the Moen warranty. We quote both, we install the one you pick, and we put the choice in writing. Bradford Remodeling Sunrise Manor is an independent service provider – we are not affiliated with Moen.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Moen Bathroom Remodeling Is Failing
Cartridge wear is the most common failure. Sunrise Manor’s hard water accelerates it – calcium builds on the brass or plastic seat and the stem starts sticking within about 4-6 years. Watch for:
- Drip from the spout with the handle off. Worn cartridge seats or a failed O-ring. If it drips cold, it usually is the cold side.
- Handle turns stiff, then slips. Lime scale binding the cartridge stem. Cleaning it buys weeks, not months.
- Lukewarm shower on a Posi-Temp valve. The pressure-balancing spool has failed – common in homes built before 2010 where the valve body never got flushed.
- Shower trim loose or corroded at the escutcheon. The retaining ring or mounting plate is failing; on tiled surrounds, this often means the substrate behind it has seen water.
- Leak at the base of the tub spout. A worn slip-fit O-ring or set-screw failure. Small fix, but unchecked it rots the drywall behind the tub deck.
Replacement Cost & What’s Included

Moen-related bathroom work in Sunrise Manor, installed and written-priced:
| Scope | Installed Range | What’s Included |
|---|---|---|
| Bathroom remodel (full) | $9,000 – $28,000 | Demo, rough-in, Moen valve and trim, tile, vanity, finish |
| Small bathroom remodel | $5,000 – $12,000 | Moen faucet and shower trim swap, tile, paint, vanity |
| Walk-in shower installation | $4,500 – $12,000 | Moen valve body, cartridge, trim, substrate, tile |
| Tub-to-shower conversion | $3,500 – $10,000 | Moen rough-in, trim, waterproofing, tile surround |
| Shower replacement | $3,000 – $8,500 | Moen valve, cartridge, and trim, tear-out, re-tile |
| Bathroom vanity installation | $800 – $3,000 | Vanity, Moen widespread faucet, drain, supply hookups |
The range is driven by valve condition, substrate condition behind existing tile, and finish level. We include the Moen part in the line-item price, not as an add-on. Written price before any work starts. Materials come from our documented brand roster – Moen bath fixtures, plus KraftMaid, Cambria, and Silestone where the scope calls for them. Every completed project is covered by the 365-Day Done Right Promise: one full year, written guarantee, free return visit if the work fails.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
An owner can safely check three things: read the model number on the trim, shut the water off at the supply stops, and confirm whether the cartridge is 1222 brass or 1200 plastic. Beyond that, opening a live Moen valve is where most homeowner jobs go wrong. The pressure-balancing spool is under spring tension, and if you lose it inside the valve body, the rough-in has to be replaced – a weekend job turns into a wall opening. If water has already reached the substrate, pulling the trim is also pulling back tile, and that is not a DIY-scope job.
We are by the book on this: background-checked technicians, live-person phone coverage, and a written price before we start. Call (844) 834-2810 and we will match the Moen part, quote the installed cost, and tell you honestly if it is a five-minute swap or a remodel conversation.
FAQs

A Moen 1222 or 1200 cartridge typically runs 4-6 years in Sunrise Manor’s hard water – well below Moen’s lifetime warranty expectation because scale, not brass, is what kills it. Soft-water homes stretch that to 8-10 years. Call (844) 834-2810 for an exact quote – estimates are free.
Yes – in most cases the cartridge, spool, or trim ring swaps and the valve body stays. Full valve replacement is only needed when the body has cracked, the pressure-balancing spool is lost inside the body, or the rough-in has corroded. We diagnose before we quote. Call (844) 834-2810.
A cartridge swap on an accessible valve runs about 30-60 minutes; a trim and cartridge job with tile work takes half a day. If the substrate behind the tile is wet, the job runs longer and the written price reflects that before we start. Call (844) 834-2810 for a real number.
Through our documented brand roster with published Moen specs – we match by model number and by measurement, and we quote OEM or quality aftermarket with you, not around you. The part goes in the written line-item price. Call (844) 834-2810 to schedule your free estimate.
Contact Bradford Remodeling Sunrise Manor
If a Moen valve, cartridge, or trim is failing in your Sunrise Manor bathroom, call (844) 834-2810 for a free estimate. We will match the Moen part, give you a written price before any work starts, and back the finished job with the 365-Day Done Right Promise. Sunrise Manor homeowners get the same live-person phone coverage 24/7, background-checked technicians, and documented brand materials on every call.
Written by the team at Bradford Remodeling Sunrise Manor, serving Sunrise Manor and nearby areas.












